Ardee Instructions

Public Channel / Instructions

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

1. For Product Updates & Information, sign up at Soothing cushion provides comfort Non-toxic Can be worn up to 3 months Easily replaced

2. Reliance Dental Manufacturing, LLC s 5805 W. 117th Place s Alsip, IL 60803 European Representative: Richard L. Milano Via Tiepolo 10126 Torino, Italy INSTRUCTIONS 1. Clean denture thoroughly. Dry denture completely as Ardee will not stick to a wet denture. 2. For upper denture: With protective cloth le ft on, lay denture on sheet of Ardee and cut the denture liner to approximate shape of plate, allowing a 1/4" extension all around. For lower denture: Same as the upper denture, but cut out the center section. 3. A ft er cutting as above, remove cloth cover from both sides of liner and lay sheet of Ardee over plate. Press Ardee sheet snugly against outside of periphery. Do not press into ridge area as air pocket will develop. 4. Have patient rinse mouth with warm water. Insert denture, seating anterior portion in place fi rst. Have patient slowly bite into place. Ardee will adapt to denture and force out all air. 5. Have patient hold in mouth under biting stress until denture feels seated (approximately 5–10 minutes). Remove denture and trim excess. Seal and smooth out rough edges around peripheral with hot spatula. On lower dentures, place a strip approximately 3/4" wide around the entire periphery, permitting about 1/8" to overlap on the outside. Th is leaves crest of ridge uncovered, but that can be fi lled in where necessary a ft er denture is worn. Seal around peripheral with hot spatula.


  • 2461 Total Views
  • 1944 Website Views
  • 517 Embeded Views


  • 0 Social Shares
  • 0 Dislikes

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Embeds 2

  • 193
  • 2